VENTILATION
The ventilation unit is housed in the cab ceiling.
To switch it on and adjust it, turn the electrical fan switch to the desired speed.
The cab becomes slightly pressurized when the ventilation system is in operation, so that the fresh
air can enter only by way of the filter installed in the rear section of the cab roof.
The fan switch can be operated only after the ignition key is inserted
.
The air flow can be regulated and directed by suitably positioning the air diffusers.
Air can be taken in fresh from outside or re circulated from within the cab by way of the relative
side inlets
■ Re-circulation inlets fully closed:
Air is taken in entirely from outside the cab through the rear grille and filtered through a paper
element positioned behind the grille.
-
it is very important that the air diffusers never be completely closed so as to allow for a steady
air flow.
To obtain a greater pressurization inside the cab, it is necessary to take the air from the outside,
therefore the inside air recirculating grille should be fully closed.
■ Working lamp switch
The front and rear working lights are ON when
the button. Is pushed. If the work light indicator lamp
is on, the instrument cluster will illuminate.
■ Wiper control switch
- Switch ON
The Wiper switch is ON when the Top button is pushed.
The Washer switch is ON when the Mid-button is pushed.
-
w
c
Once again push the buttons.
■ Windscreen Washer tank
Check the level of windscreen washer fluid in the
plastic reservoir located at the front of the radiator.
During winter,it is advisable to add a suitable antifreeze
or met
y
a
co
o
to t
e w
n
screen was
er
u
.
■ Interior Lamp
Push the button to turn the light on
and push it again to turn the light off.
84
To Next Page
Loading...
Need help?
General