10-17
Check and renewDefective controller
Check and renewDefective push switch
Inspect ,adjust neutralFaulty reverse or forward pedal
Inspect and try to push brake pedalDefective master brake pedal
Check circuit connections and repair or
renew faulty wiring
Excessive resistance in starter
circuit
Check battery and charge or renewDischarged batteryEngine cranks
slowly
Refer to the engine manualTight engine
Refer to the engine manualDefective starter motor
Inspect,repair,or renewFaulty starter motor
Check,clean and tighten connectionsDefective starter motor connections
or loose battery connections
Check and renewDefective key switch
Check and renewDefective stop light switch
Check battery and charge or renewDischarged batteryStarter motor
does not spin
CountermeasuresCausesProblems
4. STARTING SYSTEM
Check and repair or renewDefective alternator
Check and renewDefective voltage regulator
Inspect system,tighten connections and
repair or renew faulty wiring
Loose connection or broken cable in
charge system
Renew and tension correctlyAlternator drive belt is brokenNo output
from
alternator
Check and repair or renewDefective Alternator
Check condition of battery and renewDefective batteryAlternator is
charging at
high rate
(Battery is
overheating)
Check and repair or renewDefective alternator
Check,clean,and tighten circuit connectionsExcessive resistance due to loose
charging system connections
Check condition of battery and renewDefective battery:It will not accept
or hold charge.Electrolyte level is
low
Check and adjust belt tension or renewLoose or worn alternator drive beltBattery is low
in charge or
discharge
CountermeasuresCausesProblems
5. CHARGING SYSTEM
To Next Page
Loading...
Need help?
General
