This section offers you information about:
▪ how to get started with the easyScreen
▪ the easyScreen screen format
▪ preparing for testing
▪ performing screenings
▪ managing the test results
▪ settings to be made in the setup menu
▪ using the pass-checker (optional use)
▪ using the Infant Ear Simulator (optional use)
5.1 Getting Started with easyScreen
Switch on easyScreen
The easyScreen can be operated in or out of the cradle. Briefly press the Home button
on the front of the easyScreen to turn on the device. The boot-up process will take a
few seconds. During this time the display will show the splash screen.
Important information or reminders may be displayed during the boot-up process. This
could include:
• Calibration expiration reminder
• Low battery charge warning
Power-Saving Mode and Power-off
When the easyScreen is inactive for some time period, the device will go into Power
Save mode (standby) and the display will turn off. Pressing the Home button briefly
will awaken the device. Upon awakening from standby, the screen will display as it was
when it went into standby mode. (If User Login is enabled, you will need to enter your
password again when the device awakens from standby.)
Finally, after another period of inactivity, the device will power off automatically.
The time periods for power save and power off can be set in the Energy Settings on
the easyScreen.
NOTE: To manually power off easyScreen press and hold the Home button for more
than 10 seconds. Or, while in the Home screen press the Home button and a
message will display allowing you to shut off the device or cancel.
To Next Page
Loading...
Need help?
General
