4.2 Use of Equipment After Transport and Storage
Make sure the device is functioning correctly before use. If the device has been stored
in a colder environment (even for shorter time) allow the device to become
acclimatized. This can take a long time depending on the conditions (like environmental
humidity). You can reduce the condensation by storing the device in its original
packaging. If the device is stored under warmer conditions than the use conditions no
special precaution are required before use. Always ensure proper operation of the
device by following routine check procedures for audiometric equipment.
4.3 easyScreen Hardware
Display, Switch and Charging Light Indicator on the easyScreen
Viewing your easyScreen from the front side, you will see the touch screen display, the
On/Off/Home switch, and a charging light indicator (Figure 12). For detailed information
on the light modes in different conditions see section 4.4.11.4.
The top view shows the connector for
attaching the ABR preamplifier,
BERAphone
®
or the OAE probe cable
(Figure 13).
The bottom view shows the micro-USB
connector (1) and the built-in slot for
attaching a neck lanyard (2) for transport
of the device (Figure 14).
To Next Page
Loading...
Need help?
General
