6.5 Electromagnetic Compatibility (EMC)
This instrument is suitable in hospital environments except for near active HF surgical
equipment and RF shielded rooms of systems for magnetic resonance imaging, where
the intensity of electromagnetic disturbance is high.
ESSENTIAL PERFORMANCE for this instrument is defined by the manufacturer as:
• This instrument does not have an ESSENTIAL PERFORMANCE.
• Absence or loss of ESSENTIAL PERFORMANCE cannot lead to any unacceptable
immediate risk. Final diagnosis shall always be based on clinical knowledge.
Use of this instrument adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this instrument
and the other equipment should be observed to verify that they are operating normally.
Portable RF communications equipment (including peripherals such as antenna cables
and external antennas) should be used no closer than 30 cm (12 inches) to any part
of the easyScreen, including cables specified by the manufacturer. Otherwise,
degradation of the performance of this equipment could result in improper operation.
This instrument is in compliance with IEC60601-1-2:2014, emission class B group 1
NOTICE: There are no deviations from the collateral standard and allowances uses.
NOTICE: All necessary instruction for maintaining compliance with regard to EMC can be
found in the general maintenance section in this instruction. No further steps required.
To Next Page
Loading...
Need help?
General
