General notes
Directives
The machine has been built in accordance with the European regulations stated in the
manufacturer's declaration and conformity declaration.
In addition to these operating instructions, you must take account of all generally
applicable statutory and other regulations and other statutory provisions – including
those of the Operator's country - as well as the applicable environmental protection
regulations. The locally applicable regulations of the trade association or other
supervisory body must always be observed.
Safety notes
The machine must only be operated in full knowledge of the associated operating
instructions and must only be operated by persons with appropriate training.
Always read the safety notes and the motor manufacturer's operating instructions
before commissioning the machine!
The hazard and safety warnings fitted on the machine must be observed!
The machine must only be used for the purpose intended and must not be operated
without the associated safety devices. All applicable safety regulations must be
observed when operating the machine.
When sewing (gauge) parts such as needle, stitch plate, for example, are exchanged,
during threading, when leaving the workplace and during maintenance work, the
machine must be isolated from the mains supply by switching off the main switch or
pulling out the mains plug.
Daily maintenance work must only be carried out by appropriately trained persons!
Repairs and special maintenance work must only be carried out by specialist staff or
by appropriately trained persons!
Work on electrical equipment must only be carried out by specialist staffs who are
qualified for this type of work!
Work on live parts and devices is not permitted, except as specified in regulations EN
50110!
Conversions or changes to the machine must only be made taking into account all
applicable safety regulations!
For repairs, only spare parts approved by us must be used! We must expressly point
out that spare parts and accessories not supplied by us are also not checked and
approved by us. As a result, fitting and/or use of such products can adversely modify
the specified design characteristics of the machine. We accept no liability for damage
caused by the use of non-original parts.
To Next Page
Loading...