Hazard warnings
When the machine is in operation, a 1 m working area must be kept clear in front of
and behind the machine, so that unhindered access is possible at any time.
No objects must be left lying on the table during setup and adjustment of the
machine! The objects could be clamped or thrown out. Risk of injury due to parts
flying about.
Do not operate the machine without wearing eye protection!
Do not operate machines without belt guards! Risk of injury due to the drive belts!
The machines are used to produce blind stitches in industrial sewing applications.
Any use not by approved by the manufacturer is considered to be incorrect usage!
The manufacturer accepts no liability for damage resulting from incorrect usage!
Correct use also includes compliance with the operation, maintenance, adjustment
and repair measures specified by the manufacturer!
Transport, packaging and storage
Transport to the dealer / Operator
All machines are delivered fully packed.
Internal transport
The manufacturer does not accept liability for transport within the customer's place of
business or to the individual sites of use. It must be ensured that the machines are
only transported upright.
Disposal of the packaging
The packaging of this machine consists of paper, cardboard, polystyrene, wooden
pallet and VCE fleece. Correct disposal of the packaging is the customer's
responsibility.
Storage
The machine can be stored when not in use. It must then be protected from dirt, dust
and damp. For long-term storage of the machine, the individual components,
particularly their sliding surfaces, must be protected against corrosion, e.g. by means
of an oil film.
Installation and initial commissioning
The machine must only be installed and commissioned by specialist staff. All
applicable safety regulations must be strictly complied with here!
If the machine was delivered without table, the stand and table top provided must
safely support the weight of the machine and motor. Adequate rigidity of the pedestal
must be ensured, including during sewing operation.
Suitable electrical and pneumatic supply connections – as described in the "Technical
data" section - must be available at the installation location. In addition, there must be
a level, solid base and adequate lighting at the installation location.
Care of the machine
To Next Page
Loading...