GB-19
Alternatively,
1.
Press the MENU button on the remote control to display the function main menu. Press ▶" ^/
▼ □ buttons to select Main menu, and then press the SELECT button to confirm.
2.
Press
▶" ^
/
▼ □
buttons to select
S
leep
,
and then press the
SELECT
button to confirm.
3.
Press ▶" ^/▼ □ buttons to select sleep timer, and then press the SELECT button to confirm.
Sleep Setting
This function allows you to program the unit to turn to standby mode by itself after a set period of time.
1.
To activate the sleep function, press the SLEEP button on remote control repeatedly. The time will
change in the below sequence on every press:
Sleep OFF
15 minutes
30 minutes
45 minutes
60 minutes
90 minutes
120 minutes
2.
When your desired sleep time appears in the display, stop pressing the button and the sleep function
will be activated in two seconds. “ ” will show on the display. Also the time remaining until switch off
is displayed next to the symbol in the display.
3.
When the sleep timer counts down to zero, the unit will turn to standby mode. To turn the sleep
function off while the sleep timer is still counting down, press the SLEEP button repeatedly to select
“SLEEP OFF”.
Setting the Alarm
1.
Press ALARM button on the remote control, the display shows “Alarm (1 or 2): Off [hh:mm]”.
2.
Press ▶" ^/▼ □ buttons to select the Alarm number (1 or 2) and then press the SELECT button to start
the setting of the following parameters.
Press ▶" ^/▼ □ buttons to select then press the SELECT button to confirm
Enable
Off/ Daily/ Once/ Weekends/ Weekdays
Time
(Alarm On time)
Mode
Buzzer/ Internet radio/ DAB/ FM
Preset
Last Listened/ (Preset station)
Volume
0-32
Save
Save and confirm the alarm setting
3.
Finally, select "Save" and press the SELECT button to save the alarm setting. The display will show
Alarm
S
a
ved
.
When the alarm is set, the alarm icon will appear on the display.
4.
To temporarily switch off alarm, press the SNOOZE button on remote control to activate Snooze
function when alarm sounds. Press the SNOOZE button on remote control repeatedly to set snooze
period time of 5, 10, 15 or 30 minutes in turn. The set snooze time will show on the display and unit
will go to standby.
5.
To turn off the alarm when it sounds, press the Y/VOLUME dial on unit or Y button on remote control,
or ALARM button on remote control.