EN
13
Network
1. While in System Settings Mode, press 1 2 w s 3 buttons to select Network.
Press the SELECT button to confirm.
2. Press 1 2 w s 3 buttons to select from the following settings, then press the
SELECT button to confirm.
3. Press the BACK button on the unit or remote control to cancel the setting and
return to the previous menu.
System Settings
Network Wizard
SSID – select the desired wireless network. Rescan –
Scan for available networks.
Manual config – Select wireless network with DHCP
(Dynamic Host Configuration Protocol)
enable/disable.
PBC WLAN Setup
Select WPS on the unit and press the WPS button on
the modem device that you wish to connect with.
Press SCROLL/SELECT dial on unit or SELECT button
on remote control to continue.
View Settings Display the settings on the unit.
Manual Settings Select wireless network with DHCP enable/disable.
NetRemote PIN Setup
To define a PIN number to be entered before being
able to connect to the unit remotely over a network.
Network Profile View the connected network.
Clear Network
Settings
To delete the connected network memory in Network
profile.
Keep network
connected
To define whether remains connected to its network
in Standby mode and when not in Network radio
mode.
To Next Page
Loading...
Need help?
General