EN
8
Connection
1. The audio output (analogue), optical out (digital) and coaxial out (digital) are
available on the back of the unit to connect the Majority Fitzwilliam 3 with an
A/V amplifier, a HiFi system or external speakers.
2. Insert the DAB/FM antenna included in the product box into its port and extend
to the desired length.
3. Connect the WLAN antenna included in the product box to the W-LAN socket at
the back of the unit for WIFI connection.
4. Unwind the mains cable to its full length. Connect the power cable plug to the
mains socket. The unit is now connected and ready to use.
5. To switch the unit off completely, unplug the power cable from the mains port.
Be sure to connect the power cord to an AC outlet that supplies the correct
voltage. Hold the power plug when plugging into an outlet or unplugging it. Never pull
or yank on the power cord.
Network Connection
This product only supports wireless connection for network access and does not
support wired LAN connection.
Wireless network
1. First of all, check whether the control lamps (LINK/ACT) of your router light up.
2. Proceed with the operations described in the below 'Getting Started.' It is
recommended to run through the setup wizard in the System Settings section.
This unit cannot be connected to a stand alone modem directly. A router or a
modem incorporated with a router must be used. Since there are various connection
configurations, please follow the specifications and instructions of your
telecommunication carrier, internet service provider, and router setting guidebook
.
Basic Operations
To Next Page
Loading...
Need help?
General