15
a. Make sure you strictly follow the above steps to upload the program. (make sure
connected with USB cable, choose correct serial port and Board).
b. Please remove the Bluetooth/2.4G module from the main board, then upload program
again to have a check.
c. If it says “upload finished” when you do upgrade firmware, while says “upload failed”
when upload a new program, please check if there is any other Arduino software installed in the
system. Please close it if there is.
d. If both the Upgrade firmware and upload program fail, try to change the USB cable, USB
port or change a PC to have a check.
e. Try to change some new batteries. According to our test and research, it is suggested to
use rechargeable Li-ion battery or rechargeable nickel-metal hydride, nickel-cadmium which can
be bought from amazon or local shop. Or Alkaline battery with good quality like Energizer,
DURACELL.
Note 2: In case the new program uploaded to my Makeblock robot doesn't take effect.
Please reset default program referring to this FAQ and try again.
If it says “upload finished” but the uploaded program doesn’t take effect, then the board may lose
its bootloader. Please double check it refer to this document.
To Next Page
Loading...
