92
Why the serial port of LaserBot doesn’t appear on mLaser
while using Mac?
Issue: The LaserBot connects to Mac via USB cable, but the serial port doesn’t appear on mLaser.
Reason: For Mac users, you need to download driver in order to run mLaser.
1. For Mac OS Sierra user, please follow the instruction on this link to install driver
(http://www.mblock.com/docs/run-makeblock-ch340-ch341-on-mac-os-sierra/). Please note to
allow "app downloaded from anywhere".
Note: if the driver can’t be installed properly, please follow the video instruction to set allow
apps downloaded from "anywhere".
2. For other Mac users, including Mac OS High Sierra users, please download the driver on this
link
https://blog.sengotta.net/signed-mac-os-driver-for-winchiphead-ch340-serial-bridge/
3. When choose Serial port under Connect->Serial Port, please choose the port similar to
/dev/tty.wchusbserial1410.
4. If you could update firmware this time, remember to unplug the USB after successfully updated,
then plug the USB back to LaserBot again.
To Next Page
Loading...
