Makeblock mBot - Page 3

3
Why the interface of the mLaser is black rather than white
.....................................................
98
Why the mLaser showed damaged when I opened it on my Mac
............................................
99
Why the Laser is on but it cannot cut or engrave anything?
..................................................
100
Part VII XY Plotter
..........................................................................................................................
103
Why the stepper motor doesn’t run or runs abnormal?
..........................................................
103
Why I cannot draw correct pictures?
......................................................................................
107
Why it runs abnormal when testing home?
............................................................................
110
Why the laser doesn’t light on or it is weak?
..........................................................................
114
Why the laser cut discontinued lines?
.....................................................................................
117
Why Pen-up and Pen-down is not working properly?
............................................................
118
What I should pay attention when switch from mDraw to Benbox?
.....................................
120