GETTING STARTED24
SETTING UP THE MAKERBOT REPLICATOR Z18
5a. Make sure the power switch is in the
O position.
5b. Locate the power cord and plug it
into the power input port at the back
of the MakerBot Replicator Z18.
5c. Plug the power cord into
an electrical outlet.
Caution: The socket outlet must be
located near the equipment and must
be easily accessible.
5d. Switch the power on and wait for the
MakerBot Replicator Z18 to boot up. This
will take several minutes.
5 PLUG IN AND POWER ON
To Next Page
Loading...
