MakerBot Replicator Z18 - Unpacking the MakerBot Replicator Z18

GETTING STARTED16
2 REMOVE PACKAGING MATERIALS
UNPACKING THE MAKERBOT REPLICATOR Z18
Cut the straps holding the MakerBot
Replicator Z18 box in place and li o the
cardboard lid and sleeve.
Remove the tape and foam holding the
door and filament drawer of the MakerBot
Replicator Z18 open.
Peel the film o the outside of the
MakerBot Replicator Z18.
1 REMOVE THE BOX