MakerBot Replicator Z18 - Page 32

MAKERBOT DESKTOP32
5. Select how you will connect your MakerBot Replicator Z18 to your computer. If you will
print only via USB drive, clickSkip. You will be asked to choose a MakerBot 3D Printer.
ChooseReplicator Z18.
You can connect to your MakerBot Replicator via USB cable, Ethernet or Wi-Fi at any time.
WI-FI
1. Connect the USB cable to your MakerBot Replicator Z18 and to your computer. MakerBot
Desktop will automatically connect to your MakerBot Replicator Z18.
2. Go to theDevicesmenu and selectDevice Preferences.
3. Click theNetwork tab.
4. Select your network from the dropdown menu and enter your password. Your MakerBot
Replicator Z18 will automatically be connected to your Wi-Fi network.
5. Go to theDevicesmenu and selectConnect to a New Device.
6. Select your MakerBot Replicator Z18 from the list of available devices.

ETHERNET
1. Connect an Ethernet cable to your MakerBot Replicator Z18 and to your computer.
2. Go to theDevicesmenu and selectConnect to a New Device.
3. Select your MakerBot Replicator Z18 from the list of available devices.
USB
Connect the USB cable to your MakerBot Replicator Z18 and to your computer. MakerBot
Desktop will automatically connect to your MakerBot Replicator Z18.
DOWNLOADING AND INSTALLING MAKERBOT DESKTOP