MAKERBOT DESKTOP40
USING THE CAMERA
A feed of images from the onboard camera is always available when you’re connected to your
MakerBot Replicator Z18. To view the feed, click the menu icon at the right side of the status
bar to open the monitor panel. As long as you are connected to your MakerBot Replicator Z18
via USB or a local area network, the camera image will refresh every few seconds.
To take a photo, open the print monitor panel in MakerBot Desktop, mouse over the camera
view, and click Take a Photo. MakerBot Desktop will take a photo and let you save it to your local
computer.
PRINTING FROM MAKERBOT DESKTOP
To Next Page
Loading...
