16.
EXTENSION
CORDS.
Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one heavy enough to carry
the current your product will draw. An undersized cord
will
cause a drop
in line voltage resulting in
loss
of
power and overheating. Table
1
shows the
correct size to use depending on cord length and nameplate ampere rating.
If
in doubt, use the next heavier gauge. The smaller the gauge number, the
heavier the cord.
TABLE
1
MINIMUM GAUGE
FOR
CORD
SETS
Total Length
of
Cord
in
Feet
0-
6
6
-
10
10
-
12
12
-
16
I
0
-
25
I
26
-
50
I
51
-
100
I
101
-
150
18 16 14
18 16
16
16 14 12
14
12 Not Recommended
:t
I
12
Ampere Rating
More Not MOW
Than Than
AWG
VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY to the user
-
as well as damage to
the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with
voltage less than the nameplate rating is harmful to the motor.
To Next Page
Loading...
Need help?
General
