10
MARA PIGGYBACK SERVICE MANUAL
13
The shock’s lock-out piston
will be visible at this point,
carefully remove this assembly
and set aside on a lint-free
rag. Be sure to account for
the rubber face seal which
may still be in the top cap
when assembly is removed.
The rubber internal oating
piston (IFP) will be inside the
reservoir. Remove the piston
towards the hex end of the
reservoir, note orientation
and set aside. Removing
the IFP in the other direction
may damage the seals on
the threads. (IFP is replaced
during a full service.)
14
15
Using a small athead screw
driver, gently pry up to remove
the red LSC knob. Be careful
when removing this knob,
underneath are two detent
balls and springs. Pull these
out and set aside, remove the
O-ring used to retain the LSC
knob.
SHOCK TEARDOWN
To Next Page
Loading...
