EasyManua.ls Logo

Manitou MI-X 50L D C ST3A S2 - Page 86

Manitou MI-X 50L D C ST3A S2
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ân
500H - PERIODIC MAINTENANCE - EVERY 500 HOURS OF SERVICE
GREASE Mast lifting chains
- Wipe the mast lifting chains with a clean, lint-free cloth.
- Vigorously brush the chains to get rid of any foreign matter, with a hard nylon
brush and clean diesel fuel.
- Rinse the chains by means of a paint brush impregnated with clean diesel fuel and
dry them with a compressed air jet.
- Carefully check each chain for any signs of wear.
IMPORTANT
In case of technical faults, consult your dealer.
- Grease the chains sparingly ( LUBRICANTS AND FUEL).
REPLACE Engine oil
REPLACE Engine oil filter
IMPORTANT
Dispose of the drain oil in an ecological manner.
- Place the lift truck on level ground, let the engine run at idle for a few minutes, then stop the engine.
MI-X . . D C ST3A S2
- Open the engine cover ( DESCRIPTION: INSTRUMENTS AND CONTROLS).
- Unscrew the thumbscrews 1 and remove the housing 2.
- Remove the cover 3 to access filler cap 4.
- Clean the areas around the plugs and oil filter.
DRAINING THE OIL
- Remove the filler plug 4 to ensure that the oil is drained properly.
- Place a container under drain port 5 and unscrew the plug.
REPLACING THE ENGINE OIL FILTER
- Unscrew and discard the filter 6, together with its seal.
- Clean the filter holder with a clean, lint-free cloth.
- Lightly grease the seal before refitting the new filter (
FILTER CARTRIDGES AND
BELTS) on its bracket.
- Tighten the oil filter (tightening torque 15 to 17 N.m).
FILLING WITH OIL
- Refit and tighten the drain plug 5 (tightening torque 30 to 40 N.m).
- Fill up with oil (
LUBRICANTS AND FUEL) through filler port 4.
NOTE: For this operation, we recommend you use a funnel fitted with a hose.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check for possible leaks from the drain plug and the oil filter.
- Stop the engine; wait a few minutes
- Check the correct level between the two notches on dipstick 7.
- Top up the level if necessary.
3 - 24
11
7
4
1
1
2
3
6
5
647650 (19/02/2018)
M
I-X 50L/60/70 D C ST3A S2 / MI 50L/60/70 D ST3B S2 / MI 50L/60/70 G S2

Table of Contents

Related product manuals