Manitou MI-X 50L D C ST3A S2 - Page 87

MI . . D ST3B S2
- Open the engine cover ( DESCRIPTION: INSTRUMENTS AND CONTROLS).
- Unscrew the thumbscrews 1 and remove the housing 2.
- Remove the cover 3 to access filler cap 4.
- Clean the areas around the plugs and oil filter.
DRAINING THE OIL
- Remove the filler plug 4 to ensure that the oil is drained properly.
- Place a container under drain plug (5) and unscrew the plug.
REPLACING THE ENGINE OIL FILTER
- Unscrew and discard the filter 6, together with its seal.
- Clean the filter holder with a clean, lint-free cloth.
- Lightly grease the seal before refitting the new filter (
 FILTER CARTRIDGES AND
BELTS) on its bracket.
- Tighten the oil filter (tightening torque 15 to 17 N.m).
FILLING WITH OIL
- Refit and tighten the drain plug 5 (tightening torque 30 to 40 N.m).
- Fill up with oil (
 LUBRICANTS AND FUEL) through filler port 7.
NOTE: For this operation, we recommend you use a funnel fitted with a hose.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check for possible leaks from the drain plug and the oil filter.
- Stop the engine; wait a few minutes
- Check the correct level between the two notches on dipstick 8.
- Top up the level if necessary.
3 - 25
5
6
8
7
4
1
1
2
3
647650 (19/02/2018)
M
I-X 50L/60/70 D C ST3A S2 / MI 50L/60/70 D ST3B S2 / MI 50L/60/70 G S2