Manitou MLT 845 120 LSU 3-E3 Series User Manual

4-74-7
33

C - HYDRAULIC
C - HYDRAULIC AATTTTACHMENT AND HAND ACHMENT AND HAND LOCKING DEVICELOCKING DEVICE
TAKING UP AN ATTACHMENTTAKING UP AN ATTACHMENT
-- Ensure that the attachment is in a Ensure that the attachment is in a position facilitating the locking to the carriage. If it isposition facilitating the locking to the carriage. If it is
not correctly oriented, take the necessary precautions in order to move it safely.not correctly oriented, take the necessary precautions in order to move it safely.
- Check that the locking pin and the clip are in position in the bracket (fig. A).- Check that the locking pin and the clip are in position in the bracket (fig. A).
-- Place the lift truck with the jib fully lowered in front of and parallel to the Place the lift truck with the jib fully lowered in front of and parallel to the attachment, tiltattachment, tilt
the carriage forwards (fig. B).the carriage forwards (fig. B).
-- Bring the carriage under the locking tube of the attBring the carriage under the locking tube of the attachment, slightly lift the jib, incline theachment, slightly lift the jib, incline the
carriage backwards in order to position the attachment (fig. C).carriage backwards in order to position the attachment (fig. C).
- Lift the attachment off the ground to facilitate locking.- Lift the attachment off the ground to facilitate locking.
MANUAL LOCKING AND CONNECTION OF THE ATTACHMENTMANUAL LOCKING AND CONNECTION OF THE ATTACHMENT
-- TTake the locking pin and the clip on the bracket (fig. A) and locake the locking pin and the clip on the bracket (fig. A) and lock the attachment (fig. D).k the attachment (fig. D).
Do not forget to refit the clip.Do not forget to refit the clip.
- Stop the I.C. engine and keep the ignition on the lift truck.- Stop the I.C. engine and keep the ignition on the lift truck.
-- Remove the pressure of the hydraulic circuit by operating switch 1 (fig. E) oRemove the pressure of the hydraulic circuit by operating switch 1 (fig. E) on the distributorn the distributor
lever backwards and forwards 4 or 5 times.lever backwards and forwards 4 or 5 times.
-- Connect the rapid connectors Connect the rapid connectors according to the logic of the attachaccording to the logic of the attachment’s hydraulicment’s hydraulic
movements.movements.
Make sure that the rapid Make sure that the rapid connectors are clean and protect the holes which are connectors are clean and protect the holes which are not used, with the capsnot used, with the caps
provided.provided.
HAND RELEASING AND DISCONNECTING THE ATTACHMENTHAND RELEASING AND DISCONNECTING THE ATTACHMENT
-- Proceed in the opposite order to that described in MANUProceed in the opposite order to that described in MANUAL LOCKING AND CONNECTIONAL LOCKING AND CONNECTION
OF THE ATTACHMENT while making sure you put the locking pin back into the bracket (fig. A).OF THE ATTACHMENT while making sure you put the locking pin back into the bracket (fig. A).
LAYING AN ATTACHMENTLAYING AN ATTACHMENT
-- Proceed in the reverse order of paragraph TAKING UP AN AProceed in the reverse order of paragraph TAKING UP AN ATTACHMENT while making sureTTACHMENT while making sure
you place the attachment flat on the you place the attachment flat on the ground and in closed position.ground and in closed position.
AA
BB
CC
DD
EE
11
https://www.forkliftpdfmanuals.com/

Manitou MLT 845 120 LSU 3-E3 Series Specifications

General

Brand	Manitou
Model	MLT 845 120 LSU 3-E3 Series
Category	Forklifts
Language	English