1-17
1-17
LALAYING A HIGH LOAD YING A HIGH LOAD ON TYRESON TYRES
- Approach the load in the transport position in front of the pile (fig. F6).- Approach the load in the transport position in front of the pile (fig. F6).
- Put the handbrake on and set the forward/reverse selector to neutral.- Put the handbrake on and set the forward/reverse selector to neutral.
-- Lift and extend the jib (1) Lift and extend the jib (1) (2) until the load is above the (2) until the load is above the pile, while keeping an eye on thepile, while keeping an eye on the
longitudinal stability alarm longitudinal stability alarm (see: INSTRUCTIONS FOR HANDLING A LOAD: C - LONGITUDINAL(see: INSTRUCTIONS FOR HANDLING A LOAD: C - LONGITUDINAL
STABILITY ALARM). If neceSTABILITY ALARM). If necessary, move the lift truck (3) forssary, move the lift truck (3) for ward (fig. F7), driving verward (fig. F7), driving ver y slowlyy slowly
and carefully.and carefully.
-- Place the load in a horizontal position and lay it down on the pPlace the load in a horizontal position and lay it down on the pile by lowering and retractingile by lowering and retracting
the jib (1) (2) in order to position the load correctly (fig. F8).the jib (1) (2) in order to position the load correctly (fig. F8).
-- If possible, release the fork If possible, release the fork by alternately retracting and raising the jib (1) by alternately retracting and raising the jib (1) (fig. F9). Then set(fig. F9). Then set
the forks into transport position.the forks into transport position.
-- If this is not possible, If this is not possible, reverse the lift truck (1) very slowly and carefully to release thereverse the lift truck (1) very slowly and carefully to release the
forks (fig. F10). Then set them into transport position.forks (fig. F10). Then set them into transport position.
F6F6
11
22
33
F7F7
11
22
F8F8
11
F9F9
11
F10F10
To Next Page
Loading...
Need help?
General