Manitou MLT 845 120 LSU 3-E3 Series - Page 86

3-113-11

A8
A8
A8 - JIB PADSA8 - JIB PADS
CLEAN - GREASECLEAN - GREASE
To be carried out every 10 hours during the first 50 hours service, then once at 250To be carried out every 10 hours during the first 50 hours service, then once at 250
hours.hours.
- Extend the jib completely.- Extend the jib completely.
-- With a brush, apply a coat of grease (With a brush, apply a coat of grease (see: 3 - MAINTENANCE: LUBRICsee: 3 - MAINTENANCE: LUBRICANTS AND FUEL) onANTS AND FUEL) on
the 4 sides of the telescope(s) (fig. A8).the 4 sides of the telescope(s) (fig. A8).
- Telescope the jib several times in order to spread - Telescope the jib several times in order to spread the coat of grease evenly.the coat of grease evenly.
- Remove the surplus of grease.- Remove the surplus of grease.
If the lift truck is used in If the lift truck is used in an abrasive environment (dust, sand, coal.) use lubricating varnisan abrasive environment (dust, sand, coal.) use lubricating varnish (MANITOUh (MANITOU
reference: 483536). Please consult reference: 483536). Please consult your dealer.your dealer.
https://www.forkliftpdfmanuals.com/