26
R8 PRO SERVICE GUIDE
7
8
If needed, trim the cable to a length needed to be 2-4mm
past the location of the second set-screw threaded hole.
Holding the end of the cable in the cable track use a
2mm hex to thread a set-screw into the second threaded
hole on the remote knob. Torque the set screw to
0.5-0.7 N-M [4-6 lb-in].
Adjust cable tension as needed using the in-line barrel
adjuster. Using the remote, set the VTT adjustment to
“LOCK”, compress the fork to ensure the lock-out is
functioning correctly. If desired, install rubber weather
plug or weather cap by pushing down firmly onto the
knob or cable stop.
R8 PRO REMOTE KNOB INSTALL
To Next Page
Loading...
