17
R8 PRO SERVICE GUIDE
1
2
If present, remove the v-seal that was under the black
manual “VTT” adjustment knob.
Use a standard cassette tool and 1” socket to unthread
the damper top-cap from the stanchion. Remove damper
assembly from the stanchion. Inspect damper shaft
and bladder for any damage.
3
Pull damper shaft to full extension. Remove bleed-screw
on side of top-cap. Place damper top-cap over catch pan.
Cycle damper shaft several times to cycle out
old oil from damper.
R8 SEALED DAMPER SERVICE
To Next Page
Loading...
