TRANSMISSION AND TORQUE CONVERTER 5540F/YB5515 SERVICE MANUAL
7-28 Published 10-21-2010, Control# 198-04
Installation
NOTE: It is recommended, when installing the torque
converter, that the alignment tool procedure be
used. The alignment tool is available from your
Grove distributor or Manitowoc Crane Care under
part number 1902662. If the tool can not be
obtained, use the optional procedure, Installing
Without Alignment Tool.
Installing With Alignment Tool
Ensure that the flywheel face, drive plate and hardware are
clean and free from burrs or other surface imperfections.
Reference Only
To Next Page
Loading...
Need help?
General
