Manitowoc Grove RT600E - General

4-1
RT600E OPERATOR MANUAL SET-UP AND INSTALLATION PROCEDURES
4
GROVE
Published 05-02-2018 Control # 088-10
SECTION 4
SET-UP AND INSTALLATION PROCEDURES
SECTION CONTENTS
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1
Installing Cable On The Hoist . . . . . . . . . . . . . . . . 4-1
Cable Reeving . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-2
Dead-end Rigging/wedge Sockets . . . . . . . . . . . . 4-6
Installing Wedge And Socket . . . . . . . . . . . . . . . . 4-6
Dead-end Rigging . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
Erecting And Stowing The Swingaway Boom
Extension . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8
General Warnings . . . . . . . . . . . . . . . . . . . . . . . . . 4-8
Erecting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8
Stowing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9
Setting The Offset . . . . . . . . . . . . . . . . . . . . . . . . 4-14
Changing Swingaway Boom Extension From
Telescoping Type To Fixed Type . . . . . . . . . . . . 4-14
Setting The Telescoping Swingaway Length. . . . 4-15
GENERAL
This section provides procedures for installing the hoist
cable on the hoist drum, cable reeving, and erecting and
stowing the boom extension.
Installing Cable On The Hoist
NOTE: The cable should preferably be straightened before
installation on the hoist drum.
Install cable on the hoist drum in accordance with the
following procedure.
1. Position the cable over the boom nose sheave and route
to the hoist drum.
2. Position the hoist drum with the cable anchor slot on top.
3. Insert the cable through the slot and position around the
anchor wedge (1) Figure 4-1.
NOTE: The end of the cable should be even with the
bottom of the slot for the anchor wedge.
4. Position the anchor wedge in the drum slot; pull firmly on
the free end (2) of the cable to secure the wedge.
NOTE: If the wedge does not seat securely in the slot,
carefully tap (3) the top of the wedge with a mallet.
CAUTION
If cable is wound from the storage drum, the reel should
be rotated in the same direction as the hoist.
FIGURE 4-1
1
2
2
3
7312
7196
227415