3-15
RT600E OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
Published 05-02-2018 Control # 088-10
OPERATING PROCEDURES
New Crane Conditioning
Your new Grove carrier has been thoroughly tested,
adjusted, lubricated, and inspected prior to delivery.
However, during the initial hours of operation, an occasional
oil, air, or coolant leak may develop. Immediate corrective
action should be taken concerning each of these leaks to
avoid major repairs later. For detailed engine conditioning,
refer to the applicable engine manual.
The guidelines below will aid in getting a long service life out
of the crane.
1. Operate as much as possible in the half to three-
quarters throttle or load range.
2. Avoid long periods of operation with the engine at idle or
continuous maximum horsepower levels.
3. Observe instruments often and shut down at the first
indication of an abnormal reading.
4. Operate to a power requirement that allows acceleration
to governed speed when conditions require more power.
5. Check all components frequently for proper operation,
unusual noises, and excessive heating.
6. Check the engine oil and coolant levels frequently.
These guidelines should not be considered limitations but
rather as a guide for familiarization of the machine and
development of good operating habits.
Pre-Starting Checks
A complete walk-around visual inspection of the crane
should always be made with special attention to structural
damage, loose equipment, leaks, or other conditions that
would require immediate correction for safety of operation.
The following checklist items are suggested specifically for
the operator’s benefit to make certain his crane is prepared
for starting the day’s work.
Fuel Supply
Check the fuel level and make sure the cap is on tight.
Engine Oil
Check the oil level in the crankcase and fill to the FULL mark
on the dipstick. Do not overfill.
Engine Coolant
Check the coolant level in the radiator and fill to the proper
level. Do not overfill and check to make sure the cap is
secure.
Batteries
Check that the battery cables and clamps are tight and not
corroded.
Signal And Running Lights
Check all signal and running lights for proper operation.
Replace burned out lamps with those of the same number or
equivalent.
Foot And Parking Brakes
Check the foot and parking brakes for proper operation.
Daily Lubrication
Make certain that all components requiring daily lubrication
have been serviced. (Refer to Section 5 - LUBRICATION.)
Hydraulic Reservoir And Filter
Check hydraulic fluid quantity level and filter condition
indicator. Check breather for cleanliness and security.
Tires
Check for severe cuts, foreign objects embedded in treads,
and for correct inflation pressures. A tire inflation chart,
providing the correct air pressures, is located in the Load
Chart Book in the crane cab.
Wire Rope
Inspect wire rope in accordance with applicable Federal
Regulations.
Inspect sheaves, guards, guides, drums, flanges, and any
other surfaces that may come in contact with the rope for any
condition that could cause possible damage to the rope.
Hook Block
Visually inspect for nicks, gouges, cracks, and evidence of
any other damage. Replace any hook that contains cracks or
shows evidence of excessive deformation of the hook
opening, including twist. Be sure the safety latch is free and
aligned.
Boom
Ensure the large access covers on each side of the boom
base section are in place. The boom should not be operated
unless they are installed.
Air Cleaner
Check the filter condition indicator. Check filter and tubing for
security.
Access Hole Covers (CE Units)
Ensure the covers are installed in all access holes in the
boom and the outrigger beams.
227415
To Next Page