EasyManuals Logo

Manitowoc Shuttlelift CD5515-2 Service And Maintenance Manual

Manitowoc Shuttlelift CD5515-2
293 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #136 background imageLoading...
Page #136 background image
GROVE Published 1-20-2017, Control# 483-02 5-35
CD5515-2/YB5515-2 SERVICE MANUAL PREVENTATIVE MAINTENANCE
5
Do not apply to recently primered and painted areas for
at least 48 hours after paint is properly dried and cured.
For minor touch up areas a 24 hour period is needed for
cure time before applying treatment.
NOTE: Crane must be completely dry before applying
treatment.
Do not allow product to puddle or build-up on weather
stripping, rubber gaskets, etc. Crane should not have
puddles or runs evident anywhere.
To ensure proper coverage of treatment, the product
needs to be fogged on the crane.
Use of pressure pots to apply the treatment to the crane
being processed is recommended.
Carwell treatment is available in 16 ounce spray bottles
from Manitowoc Crane Care (order part number
8898904099).
After application of the treatment is complete, wash or
clean film residue from lights, windshield, grab handles,
ladders/steps and all access areas to crane, as
necessary.
Please contact Manitowoc Crane Care should you have any
questions.
Areas of Application
Refer to Figure 5-54
The underside of the unit will have full coverage of the
rust inhibitor. These are the only areas that a full coat of
the rust inhibitor is acceptable on the painted surfaces.
Areas include; valves, hose end and fittings, swivel,
pumps, axles, drivelines, transmission, slew ring
fasteners and all interior surfaces of the frame.
Frame application areas are; hose ends and fittings, all
unpainted fasteners and hardware, all bare metal
surfaces, outrigger pads, and back up alarm hardware.
Superstructure applications are; hose ends and fittings,
wire rope on hoist roller tensioning springs on hoists, all
unpainted fasteners and hardware, valves, slew ring
fasteners and all bare metal surfaces.
Boom application areas are; pivot pins, hose ends and
fittings, jib pins and shafts, all bare metal surfaces,
headache ball pins/ hook block pins and fasteners.
All hardware, clips, pins, hose connections not painted
will have treatment applied.
Reference Only

Table of Contents

Other manuals for Manitowoc Shuttlelift CD5515-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc Shuttlelift CD5515-2 and is the answer not in the manual?

Manitowoc Shuttlelift CD5515-2 Specifications

General IconGeneral
BrandManitowoc
ModelShuttlelift CD5515-2
CategoryConstruction Equipment
LanguageEnglish

Related product manuals