Mankati FULLSCALE XT PLUS - Page 20

www.mankati.com
18
ABSrequired(Default:Extruder,230
℃；
Build plate, 70
℃）
Preheat ABS Bed: PreheatbuildplatetotheworkingtemperatureofABSrequired(
Default:Buildplate,70
℃
).
1.6 - Leveling Bed: Buildplatecalibrationassist-function.Rotatethebutton,theextruderwill
movetonextpositioninclockwisedirectionfromtopview.
1.7 - Cool down: Cooldowntheextruderandbuildplatetonormaltemperature.
2 - Control: Adjust printer settings
2.1 - Temperature:
Nozzle: Left temperature setup
Nozzle 2: Right temperature setup
Bed: Build plate temperature setup
Fan speed: Cooling fan speed setup
Auto Temp: All the above data setup automatically
2.2 - Motion: PleasedoNOTchangeanydatainthismenuifwithoutspecialistexperience.
Accel:Acceleratedspeedofextrudermotion
Vmax x: Max speed in X direction
Vmax y: Max speed in Y direction
Vmax z: Max speed in Z direction
Vmax e: Max speed of feeding motor
Vmin: Min printing speed
VTrav min: Min travel speed
Amax x: Max accelerated speed in X direction
Amax y: Max accelerated speed in Y direction
Amax z: Max accelerated speed in Z direction
Amax e: Max accelerated speed of feeding motor
A-retract: Accelerated speed of retract
Xsteps/mm: Transmission ratio of X motor
Ysteps/mm: Transmission ratio of Y motor
Zsteps/mm: Transmission ratio of Z motor
Esteps/mm: Transmission ratio of feeding motor
2.3 - Restore Failsafe: PleasedoNOTchangeanydatasettinghereinthismenu.
2.4 - Save memory: Record the coordinate of printing stop
2.5 - Restore factory: Restore the manufacturer default settings
2.6 - Firmware version:Currentrmwareversion
LCD Menu
Menus in Printing Process
During the printing, you can press the knob to change some printing settings.
1. Tune: Re-set some parameters
-
F/R: the actual printing speed takes the percentage of the pre-set speed in the software. It can be
adjusted while printing according to the actual situation.
-
Nozzle: Temperature setup of left nozzle
-
Nozzle 2: Temperature setup of right nozzle
-
Bed: Temperature setup of build plate
-
Fan speed: Fan speed setup
-
Flow: Filament feeding flow rate
-
Flow 0: Filament feeding flow rate of left nozzle
-
Flow 1: Filament feeding flow rate of right nozzle
-
Auto Temp: Set all the above temperature automatically
-
Change filament: To stop the printing and change the filament. It will record the printing stop position
so as to continue to print after filament changing.
2. Control: Please do NOT change any data in this menu if without specialist experience.
3. Pause: To stop the printing, but it will record the printing stop position to continue the printing.
4. Stop Print: To finish the printing job