Mankati FULLSCALE XT PLUS - Unload the Filament

www.mankati.com
35
Unload the Filament
1. Heat the nozzle to the required temperature of
lament.Forexample,PLA210
℃
and ABS 235
℃
.
2. Pullthelamentoutindirectionofperpendicular
tothefeedermotorhardlyandquickly.
2. Done.
Note:
1. If the filament is stuck, please find solution in
troubleshooting chapter.
2. If your machine stops working for a long time,
please switch off the printer to avoid the filament
carbonized, which will cause the nozzle clogged.
Clean the dust on the build plate, that will extend
the lifetime of the kapton tape.