Mankati FULLSCALE XT PLUS - Maintenance; Build Plate; Cleaning the filament feeder

www.mankati.com
37
Maintenance
Build Plate
Cleaning the filament feeder
1. Removetheblackscrewonthefeedermotortotally. 2. Select“Prepare”>“moveaxis”>“move1mm”>“move
extuder”.Thefeedergearwillstarttowork.
3. Cleansmallplasticparticleswithabrush.
Ensure that the plate is clean. Bubbles, scratches, dust, and oil from your hands are avoided.
1.Usetweezertoremovelamentresidue.
2.Donottouchtheplatformglasswithsharpthings.
3.Ifnotusingtheprinterforalongtime,pleasecleanupthetape,cleantheglassandfullyreleasethefourblackscrewsunderthebuildplate.
After a lot of printing, the wheel in the filament feeder might accumulate small plastic particles.
You can clean this with a brush.