Mankati FULLSCALE XT PLUS - Page 32

www.mankati.com
30
Stick the Kapton tape
4.
Cut the tape off along
the edge of the heat bed
glass.
5.
Cut off the parts on
the screws when sticking
thethirdline.Ifsomebig
bubbles appear, just use a
needletostickintothem.
Then smooth them with
yellowboard.
6.
After sticking the tape on
the plate, please uncover
theothersideofthetape.
Note:
After several
printing, the stickiness
is not strong enough,
please change the
tape.
6.1
6.2