Mankati FULLSCALE XT PLUS - Page 34

www.mankati.com
32
Leveling Build Plate
3. If the gap distance
between nozzles and build
plateisstilltoobig(more
that 4-5mm) after “Auto
home”,pleaseadjustthe
limit stopper on the rear
sideofyourmachine.
Loosen the 2 screws then
move it upwards a few
mm.
6. Repeat to adjust the 4
corners a little at least 3-4
times to ensure the best
gapdistance.
4. Now, you can start to
adjustthefourcorners:
Insert a business card
into the gap between
the extruder and the hot
bed, then move it back
andforth.Youshould
feel some friction on the
card but still able to easily
move the card between
the gap without tearing or
damagingthecard.
5. In the same way, adjust
the left 3 corners in anti-
clockwisedirection.