Mankati FULLSCALE XT PLUS - Page 49

www.mankati.com
47
How To
5. Use2spanners:one
forxingattheupper
location, the other for
loosen the nozzle under,
thentakeitoff.
How to clean the nozzle?
1. Heat the nozzle to
210 degrees, making
residuallamentinthe
nozzle automatically
owout.
2. After heating and
lamentextruding,clean
nozzle with the drill in
toolbox.Payattention
not to break off it into
thenozzle.