16
Safety cautions on handling batteries
Always follow the points below when using batteries to avoid
electrolyte leakage, overheating, fire, rupturing, ingestion, etc.
• Electrolyte leakage or corrosion may occur if batteries are kept
inside the recorder for prolonged periods of time. If the recorder
is not to be used for a prolonged period, remove the batteries to
prevent electrolyte leakage.
• Make sure that the + and – markings on the batteries are
aligned with the corresponding markings in the battery case
and the battery holder.
• Do not insert old or exhausted batteries into the recorder.
• Do not mix the type of battery, and do not use both old and new
batteries together.
• If the recorder does not operate correctly, replace the old
batteries with new ones.
• If electrolyte has leaked, thoroughly wipe the inside of the
battery holder, and then insert new batteries.
Battery remaining indicator
The recorder operates using commercially available AA size
alkaline or Ni-MH batteries. During operation, the battery
remaining indicator is as follows.
Indicator Meaning
There is still ample battery power remaining.
The amount of battery power remaining has decreased
to approximately half.
Only a small amount of battery power remaining.
There is not enough battery power remaining to record
or playback. Either replace the batteries with new ones,
or recharge the rechargeable batteries.
If you continue recording while this indicator is flashing,
recording/playback will stop, and the recorder will shut
down.
The AC adapter is being used. The adapter power
supply is valid.
To Next Page
Loading...
Need help?
General
