Marantz SR7000 - Remote Control Indicators and Modes; Control Indicator and Mode Switching; Basic Operation: Remote Control Modes; Using the Remote in USE Mode

ENGLISH
Q) CONTROL indicator
Indicates when the < • ► {CURSOR/TRANSPORT CONTROL
switching) 0 is in a transport control mode such as PLAY. STOP, etc.
• It the LCD flickers when a button is pressed in order to transmit a
command or when in the LEARN mode, the transmission or
learning is not possible. In such a case, please replace the
batteries.
• This remote controller uses non-volatile memory, so that learned
codes and macros will be preserved even if the batteries are
removed.
USE MODE
The remote controller will normally be used in the USE mode.
It comes preset with codes commonly used to control 11 types of
components manufactured by Marantz and Philips, including DSS,
DVD. TV. LD, VCR. AUX, TUNER. CD, TAPE, CD-R/MD, and AMP, as
well as many others that utilize the RC-5 remote control language.
1. Press one of the Function buttons [S once to change to another
component's commands, for example the LD button.
2. LD will be displayed on the LCD and the function codes will be
set to operate the laser disc player, and if you double clicked the
LD function button, the preamplifier or receiver's input will be
changed as well.
3. Now you can operate the laser disc player. When a button is
pressed, the symbol indicates that a remote code is being
transmitted, is not displayed if a button for which no code
has been set is pressed.
4. The Jog Dial [3 is used to select any one of up to 10 direct
operations that can be performed for each of the 11 functions
(LD, TV. AMP. etc.). Rotate the Jog Dial fl] to select one of these
commands. The number of the current page is indicated by O-
m
Page numbers cycle up or down, for example 0 O -> 0
D etc. or0-»a-»O etc, depending on which
way the Jog Dial [6) is rotated.
The last page position for any given command function Is
retained in the memory even if the remote controller is switched to
the ccammand function for another component, (Last Memory)
If it is left for approximately 1 minute without pressing any
buttons, all items on the LCD will go off except the function
indicator.
Even if the display goes off, the remote controller will hold the
page position and other data, The display may be activated
again by pressing any button,
LEARN MODE
The remote controller is capable of learning and memorizing the
remote control codes used by almost any other remote controller you
may already own.
• If no commands have been programmed for a particular function
button, the remote controller will transmit whatever codes have
been factory preset,
• The following example shows how to program your remote
controller and how to use the codes for a laser disc player (LD).
• The remote controller infrared receiver is located at the top of the
remote controller.
1. Use a ballpoint pen or other sharp point to press the MODE
button D] until the LEARN indicator is displayed. Each time you
press this button, the mode will cycle through LEARN ^ NAME
^USE.
Stop when the LEARN indicator starts to blink.
2. Place the laser disc's remote controller so that its infrared signal
transmitter is facing the infrared signal receiver on the Marantz