What to do if no sound is output from the surround back speaker on Marantz Stereo Receiver?
If there is no sound from the surround back speaker, verify the following: Ensure the surround speaker cable is properly connected. Note that if STEREO has been selected for Surround mode, no sound will be output from the surround speaker. The surround back channel is only active in THX surround EX mode, so set the receiver to THX Surround EX mode.
What to do if no sound is output from the surround speaker on Marantz SR8300 Stereo Receiver?
If you're not getting any sound from the surround speaker, here's what to check: Make sure the surround speaker cable is properly connected. If STEREO is selected for Surround mode, no sound will be output from the surround speaker, so try a different Surround mode. Also, ensure that Surround = NONE hasn't been selected in SETUP mode; if it has, correct the setting.
What to do if no sound is output from the center speaker on Marantz SR8300 Stereo Receiver?
If there's no sound coming from the center speaker, check these items: Ensure the center speaker cable is correctly connected. If STEREO is selected for Surround mode, no sound will come from the center speaker, so select another Surround mode. Also, verify that Center = NONE hasn't been selected in SETUP mode; if it has, make the correct setting.
Safety and operational guidelines for using the equipment.
Guidelines for proper placement and setup of the unit.
Safety measures to follow before connecting any cables.
Details on the amplifier's power, feedback, and sonic capabilities.
Information on surround sound formats, decoders, and digital audio.
Explains THX standards, DTS, DTS-ES, DTS 96/24, and SRS Circle Surround II.
Details Dolby Digital EX and Dolby Pro Logic II surround sound features.
Controls for screen navigation, input selection, and volume adjustment.
Programming RC3200A to learn codes from other remote controls.
Creating sequences of commands triggered by a single button.
Configuring input assignments and speaker sizes/distances.
Adjusting PLII music parameters, dimension, and CS II settings.
Solutions for no power, no sound, or incorrect channel output.
Troubleshooting noise, weak reception, and incorrect signal playback.
Safety and operational guidelines for using the equipment.
Guidelines for proper placement and setup of the unit.
Safety measures to follow before connecting any cables.
Details on the amplifier's power, feedback, and sonic capabilities.
Information on surround sound formats, decoders, and digital audio.
Explains THX standards, DTS, DTS-ES, DTS 96/24, and SRS Circle Surround II.
Details Dolby Digital EX and Dolby Pro Logic II surround sound features.
Controls for screen navigation, input selection, and volume adjustment.
Programming RC3200A to learn codes from other remote controls.
Creating sequences of commands triggered by a single button.
Configuring input assignments and speaker sizes/distances.
Adjusting PLII music parameters, dimension, and CS II settings.
Solutions for no power, no sound, or incorrect channel output.
Troubleshooting noise, weak reception, and incorrect signal playback.
General| Total Harmonic Distortion (THD) | 0.08% |
|---|---|
| Signal-to-Noise Ratio | 100 dB |
| Input Impedance | 47k ohms |
| Weight | 35.3 lbs |
| Type | AV Receiver |
| Channels | 7.1 |
| Input Sensitivity | 200 mV |
| Video Inputs | Composite, S-Video, Component |
| Surround Sound Formats | Dolby Pro Logic II |
To Next Page
