TS 910 TRANSFER SWITCH
PM140 REV 2 14/01/23 35 Thomson Power Systems
18.6.1.2 Configuration Jumpers
The TSC 9 controller provides 9 user-configurable functions which utilize
jumpers located directly on the printed circuit board as per FIGURE 2.
They are used for configuration of main system operating parameters
such as voltage, phases and timers. Refer to Section 18.15
(CONFIGURATION INSTRUCTIONS) for further information.
18.6.1.3 KW Adjustment Switches
The TSC 9 controller provides 2 KW load adjustment switches which are
utilized when the KW Load Shed optional accessory is provided with the
transfer Switch. Additional information on TS 910 kW Load shed optional
accessory can be obtained from our Website:
(
www.thomsontechnology.com).
To Next Page
Loading...