Mark-10 ESM301 User Manual

Model ESM301 / ESM301L Test Stand User’s Guide
17
4.15 Return to Default Settings (DEFAULT SETTINGS)
This setting provides a quick return to factory settings, as follows:
SPEED: 10 in/min
UP SPEED: 10 in/min
DOWN SP: 10 in/min
AUTO RETURN: off
CYCLING: 00000 (off)
HI LIMIT: +12.000 / +19.000
LO LIMIT: -12.000 / -19.000
OVERLD: off
PRELOAD: off
LOAD HOLDING: off
BREAK DETECT: off
CONTROL: CONSOLE
BAUD RATE: 115200
STOP & PAR: 8-1n
UNITS: in/min
KEYS: maintained
PASSWORD: 0000 (off)
Default setting: off
Available settings: off, on
Label Description
+ or –
Cycles through the available settings
ENTR
Returns to the Test Feature Setup menu
ESC
Exits the feature without saving changes
4.16 Password (NEW PWORD)
If desired, a password can be set to prevent unwanted changes to test features. The password can be set
to any number between 0000 and 9999. The default setting of 0000 indicates that the password is
disabled, and that the user can freely enter the Test Feature Setup menu. If misplaced or forgotten, the
password may be reset through a code activation process. Details on this may be found in the Function
Activation section.
Default setting: 0000 (off)
Available settings: 0000 – 9999
Label Description
+ or –
Increases or decreases the value.
ENTR
Returns to the Test Feature Setup menu
ESC
Exits the feature without saving changes
D E F A U L T ? : N O
E S C − + E N T R
N E
W
P
W
O R D 0 0 0 0
E S C − + E N T R

Mark-10 ESM301 Specifications

General

Brand	Mark-10
Model	ESM301
Category	Test Equipment
Language	English