marposs M32A - Table of Contents

- User Manual
4
Index
1. STANDARDS AND WARNINGS 5
1.1 Description of the manual .................................................................................................................... 5
1.2 Original version .................................................................................................................................... 5
1.3 Final test and warranty ......................................................................................................................... 5
1.4 General safety indications.......................................................... Errore. Il segnalibro non è definito.
1.5 Key to symbols ........................................................................... Errore. Il segnalibro non è definito.
1.6 Technical Assistance ........................................................................................................................... 6
2. GENERAL DESCRIPTION AND TECHNICAL DATA 7
2.1 Technical specification ......................................................................................................................... 8
2.2 Storage and working Environment ....................................................................................................... 8
2.3 Operating characteristics ..................................................................................................................... 9
3. USING THE E32A SSR INTERFACE 11
3.1 Enabling the output: PROBE OUTPUT signal ...................................................................................11
3.1.1 MIDA SET arm cycle diagram (Enable P.O. =VTRUE) ................................................................11
3.1.2 Alternative MIDA SET arm cycle diagram (Enable P.O. =ARO) ..................................................12
3.1.3 Manual MIDA TOOL EYE arm cycle diagram (Enable P.O. =TRUE) ..........................................13
3.1.4 Alternative Manual MIDA TOOL EYE arm cycle diagram (Enable P.O. = ARO) .........................14
3.1.5 Electrical MIDA TOOL EYE arm cycle diagram (Enable P.O. =TRUE) ........................................15
3.1.6 Alternative Electrical MIDA TOOL EYE arm cycle diagram (Enable P.O.=ARO) ........................16
4. OTHER FUNCTIONS 17
4.1 Function Inhibit ...................................................................................................................................17
4.2 Delay and skip PROBE OUTPUT (JP5-JP6) .....................................................................................18
4.3 Recognising the connected arm ........................................................................................................19
4.4 Selecting SINK/SOURCE operating mode (JP1) ..............................................................................19
5. DIAGNOSTICS 21
5.1 E32A: Alarms .....................................................................................................................................21
5.1.1 Alarm signals ................................................................................................................................21
6. DEFINITION OF SINK/SOURCE AND SSR CONNECTIONS. 23