CE
This product complies with EMC requirements as defined by directives:
89/336/CEE dated 03.05.1989
92/31/CEE dated 28.04.1992
93/68/CEE dated 22.07.1993
This product is intended to operate in industrial locations; it is not intended for connections to a
public mains network but is intended to be connected to a power network from a high or medium
voltage transformer.
SAFETY WARNINGS
Follow the grinder manufacturer’s safety procedures.
Follow all safety procedures at the gauge system location.
There are NO Customer serviceable parts inside the P5. Always call technical service
M
ANUFACTURER: MARPOSS S.p.A.
A
DDRESS: Via Saliceto 13, Bentivoglio (BO) Italia
http://www.marposs.com
S
YSTEM
S
OFTWARE
: from V3.1 to V3.5
H
ARDWARE
M
ODEL
: _________________
A
PPLICATION
S
OFTWARE
: _________________
MANUAL CODE NO.: D293xxxxUC
D
ATE OF ISSUE: May 10, 2002
E
DITION: -------------------
I
SSUED BY: MARPOSS S.p.A., Via Saliceto 13, Bentivoglio (BO) Italy
Data reported in this book are to be referred to standard system software releases indicated in this page.
In case of application with different software release the relevant manual can be requested to the
nearest Marposs Distributor Office making reference to software code “CMxxxxxxxx” printed on the label
in the electrinic gauge back.
MARPOSS S.p.A. mai change the features and data reported in this booklet in any moment and without
notice, in order to inprove the product.
The descriptions reported in this book do not authorize any tampering by non-authorized personnel.
The warranty on the equipment will decay if such tampering is found.
Print performed from: www.marposs.com
© Copyright
2002
To Next Page
Loading...
Need help?
General
