Martin MAC 2000 Performance Service Manual (English)

Other manuals for Martin MAC 2000 Performance

Questions and Answers:

M
Melissa EscobarAug 1, 2025
What to do if my Martin MAC 2000 Performance Lighting Equipment has no light and displays a 'LERR' error message?
- F
  fryeerinAug 1, 2025
  If your Martin Lighting Equipment shows a 'LERR' message and there is no light, the issue may be due to several reasons. First, ensure that the transformer settings match your local AC voltage and frequency by disconnecting the fixture and checking the settings. Also, the lamp might be blown, not installed, or too hot to ignite, so disconnect the fixture and replace the lamp if needed, install the lamp if it is not installed, or allow the lamp to cool for 5-10 minutes before trying again. Finally, check that the lamp access plate is fully seated and locked, as an open safety switch will prevent the lamp from working.
C
Carolyn ClarkAug 5, 2025
How to fix Martin MAC 2000 Performance that is completely dead?
- W
  Wayne JonesAug 5, 2025
  If your Martin Lighting Equipment is completely dead, start by checking that the power is switched on and all cables are securely plugged in. If the issue persists, the primary fuse located near the mains inlet might be blown; disconnect the fixture and replace the fuse. Additionally, check the secondary fuses located on the PCB inside the base and replace them if necessary.
P
Patricia MerrittAug 11, 2025
Why does my Martin Lighting Equipment lamp cut out intermittently?
- R
  Randall DixonAug 11, 2025
  If the lamp in your Martin Lighting Equipment cuts out intermittently, it could be due to the fixture overheating. Allow the fixture to cool down, clean the air filters, and reduce the ambient room temperature. Also, verify that the transformer settings match your local AC voltage and frequency by disconnecting the fixture and checking the settings.
K
Kathleen MatthewsAug 15, 2025
What to do if Martin Lighting Equipment fixtures reset but respond erratically to the controller?
- S
  Sara MortonAug 15, 2025
  If your Martin Lighting Equipment fixtures reset correctly but respond erratically or not at all to the controller, there might be a bad data link. Inspect the connections and cables, fix any poor connections, and repair or replace damaged cables. Ensure the data link is terminated by inserting a termination plug in the output jack of the last fixture on the link. Check that the fixtures are correctly addressed and the protocol settings are correct. Try bypassing one fixture at a time until normal operation is regained by unplugging the XLR in and out connectors and connecting them directly together. If the XLR pin-out on fixtures does not match (pins 2 and 3 reversed), install a phase-reversing cable between the fixtures or swap pins 2 and 3 in the fixture that behaves erratically.
K
Kevin PrattAug 20, 2025
Why does the mechanical effect on my Martin Lighting Equipment lose position?
- M
  Michael KnightAug 20, 2025
  If the mechanical effect on your Martin Lighting Equipment loses position, it may be that the transformer setting does not match local voltage. Disconnect the fixture and check the transformer setting, correcting it if necessary. For issues related to cleaning, adjustment, or lubrication of the mechanical train, contact a Martin technician for service.
C
Christina KellerAug 26, 2025
How to troubleshoot wandering magnetically indexed effects on Martin MAC 2000 Performance Lighting Equipment?
- M
  Mary McneilAug 26, 2025
  If the magnetically indexed effect on your Martin Lighting Equipment resets correctly but wanders after the fixture reaches operating temperature, disable effects feedback. Contact a Martin technician for service.