Masimo Rad-G User Manual (English)

Other manuals for Masimo Rad-G

Operator's Manual80 pages

Directions For Use76 pages

Questions and Answers:

P
Pamela CalhounJul 28, 2025
What to do if Masimo Rad-G Medical Equipment shows 'An Error Occurred Please Start Over'?
- J
  Jason StephensJul 28, 2025
  If the Masimo Medical Equipment displays 'An Error Occurred Please Start Over', try the following: * Repeat the screening. * Verify the sensor type and size, then re-apply the sensor. Ensure proper application following the Directions for Use. * Check for restricted blood flow to the sensor site. * Verify sensor placement; re-apply or relocate the sensor. * Replace the sensor or cable if necessary. * Minimize movement at the measurement site. This may be due to a damaged or malfunctioning sensor, incorrect sensor type or application, excessive motion, or low perfusion.
V
Virginia MitchellAug 2, 2025
What to do if Masimo Rad-G Medical Equipment says 'Low Battery Please Charge'?
- M
  Matthew AllenAug 2, 2025
  If the Masimo Medical Equipment displays 'Low Battery Please Charge', the battery charge is low. To resolve this, charge the battery by connecting the device to AC line power.
A
Anthony PerezAug 7, 2025
Why does my Masimo Rad-G Medical Equipment say 'Battery Depleted Shutting Down'?
- A
  allendominiqueAug 7, 2025
  If the Masimo Medical Equipment displays 'Battery Depleted Shutting Down', it means the battery charge is completely depleted. You should charge the battery immediately by connecting the device to AC line power.
D
Daryl HowardAug 11, 2025
What to do if Masimo Medical Equipment says 'Sensor Off Patient'?
- L
  lgarrettAug 11, 2025
  If the Masimo Medical Equipment displays 'Sensor Off Patient', it means the sensor has been removed from the patient during spot check monitoring. Place the sensor back on the patient to continue the spot check.
J
Jamie BowenAug 17, 2025
Why does my Masimo Rad-G Medical Equipment say 'Device Too Hot Shutting Down'?
- A
  Ashley JohnsonAug 17, 2025
  If the Masimo Medical Equipment displays 'Device Too Hot Shutting Down', the operating temperature is too high. Consult the Environmental Section for guidance.
P
Pamela PerezAug 21, 2025
What to do if Masimo Rad-G is unable to obtain respiration rate?
- J
  Joshua BrownAug 21, 2025
  If the Masimo Medical Equipment is 'Unable to Obtain Respiration Rate', it means RRp cannot be determined. Manually count the respiration rate or select a respiration rate range.

Masimo Rad-G Specifications

General

Type	Handheld Pulse Oximeter
Ingress Protection	IP22
Operating Temperature	5°C to 40°C
Storage Temperature	-20°C to 60°C
SpO2 Range	0% to 100%
Pulse Rate Range	25 – 240 bpm
Battery Type	Rechargeable Lithium-ion
Connectivity	Bluetooth
Perfusion Index Range	0.02% to 20%
PVI Range	0% - 100%
Humidity	10% to 95% (non-condensing)