Need help?Do you have a question about the Masimo Rad-8 and is the answer not in the manual?
General| Display | LED |
|---|---|
| Pulse Rate Range | 25-240 bpm |
| Pulse Rate Accuracy | ±3 bpm |
| Trend Time | 72 hours |
| SpO2 Range | 0-100% |
| SpO2 Accuracy | ± 2 digits (70-100% SpO2) |
| Power Supply | AC adapter or rechargeable battery |
| Perfusion Index (PI) Range | 0.02% - 20% |
| PVI Range | 0-100 |
| Operating Temperature | 5°C to 40°C (41°F to 104°F) |
| Storage Temperature | -4°F to 140°F (-20°C to 60°C) |
| Relative Humidity | 10-95% non-condensing |
| Altitude | Up to 15, 000 ft (4, 572 m) |
Explains how SET technology distinguishes arterial blood from venous blood during motion.
Visualizes the signal processing flow from light input to output power.
Diagram of the horizontal Rad-8 front panel with numbered controls.
Diagram of the vertical Rad-8 front panel with numbered controls.
Details the function of each control and indicator on the Rad-8 front panel.
Describes remaining front panel controls: Battery indicator, Speaker, and Cable Connector.
Details the connectors and ports located on the rear panel of the Rad-8.
Details AC power requirements, connection, and electrical safety precautions.
Step-by-step guide for initial setup and basic operation of the Rad-8.
Details procedures for verifying sensor alarms and alarm silence functionality.
Details default and user-configurable settings for various device parameters.
Key points to ensure successful pulse oximetry monitoring.
Guidelines for using Masimo sensors and avoiding tissue damage.
Describes the low perfusion indicator and related cautions.
Steps to take when SpO2 readings are questionable or unavailable.
Details the Signal IQ indicator for plethysmogram signal quality.
Provides instructions for optimal sensor placement to ensure accurate readings.
Explains how to access and adjust SpO2 and pulse rate alarm limits.
Explains how to adjust the volume of the device's audible alarms.
Details how to configure the duration of alarm silence.
Explains how to adjust the delay before audible alarms are triggered.
Describes the three sensitivity modes (NORM, APOD, MAX) and their usage.
Explains how to enable or disable the FastSat feature for rapid saturation tracking.
Guides users on accessing and adjusting the averaging time parameter.
Details alarm priorities, parameters, and types.
Specifies the settable ranges for SpO2 and pulse rate alarm limits.
Explains how to silence audible alarms and the behavior of the Alarm Bell.
Lists various display messages and their corresponding solutions.
Continues the list of display messages and their solutions.
Provides solutions for common operational problems with the Rad-8 system.
Offers solutions for further troubleshooting scenarios.
Lists the accuracy specifications for SpO2, pulse rate, and low perfusion.
Crucial warnings regarding the use and handling of sensors and cables.
General information and cautions for using Masimo SpO2 sensors.
Procedure for cleaning reusable Masimo sensors and patient cables.
Details how to clean the outer surface of the Rad-8 Pulse Oximeter.
Steps to test the Rad-8's performance after repairs or routine maintenance.
Optional procedure for testing the Rad-8 using a Masimo SET Tester.
States that only authorized personnel should perform repairs.
Outlines the steps for returning the Rad-8 for service or repair.
To Next Page
