Masport MG 3000 STD NG - Installation; Minimum Installation Clearances; Shims; Gas Connection

MINIMUMINSTALLATIONCLEARANCES(Toheatsensitivesurfaces)
*
FLUEDAPPLIANCES
NOFLOORPROTECTOR(HEARTH)ISREQUIRED
Alcoveinstallationnotpermitted.
UN-FLUEDAPPLIANCES
NOFLOORPROTECTOR(HEARTH)ISREQUIRED
Alcoveinstallationnotpermitted.
*
NOTE:Theclearancesshownareforfirehazardonly.Fordurabilityoffinishesorsurfacesyou
shouldcontacttherelevantmanufacturerfortheirspecification.MASPORTacceptsnoresponsibility
forthedeteriorationofsurfacesorfinishes.
INSTALLATION
SHIMS
Theglasspanelsareprotectedfromshippingdamagebypapershimsfittedbetweenthefrontandside
glasses.Beforelightingtheheater,removetheshims.
GAS
Accesstothegasconnectionpointisobtainedbyremovingthecoverpanelontherearofthecabinet.
(Fourscrews)
ConnectionismadetotheBostonandOdessaLPmodelsusinga3/8”BSPfitting.Theothermodels
(exceptSantaFeflueless)usea1/2”BSPfitting.
3