plug because heat and deposits will cause
the spark plug to slowly break down and
erode. If electrode erosion becomes
excessive, or if carbon and other deposits
are excessive, you should replace the spark
plug with the specified plug.
8-21
Specified spark plug:
DPR8EA-9（NGK）
Installation
1. Measure the electrode gap with a wire
thickness gauge and, if necessary, adjust the
gap to specification.
Spark plug gap: 0.8-0.9 mm
a. Spark plug gap
2. Clean the gasket surface.
3. Install the spark plug and tighten it to the
specified torque.
Tightening torque:
Spark plug:
17.5 Nm (1.75m·kgf, 12.93 ft·lbf)
NOTE:
If a torque wrench is not available when you
are installing a spark plug, a good estimate of
the correct torque is 1/4 to 1/2 turn past
finger tight. Have the spark plug tightened to
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
To Next Page
Loading...
