8. Fill with the specified amount of the
recommended oil. Set the dipstick and
tighten it.
Recommended oil:
Oil quantity:
Oil filler not replaced:
1.9L (1.67 lmp qt, 1.97 US qt)
Oil filler replaced:
2.0L (1.76 lmp qt, 2.08 US qt)
8-12
In order to prevent clutch slippage (since the
engine oil also lubricates the clutch), do not
mix any chemical additives. Do not use oils
with a diesel specification of “CD” or oils of
a lower quality than specified.
Make sure that no foreign material enters
into the crankcase.
9. Start the engine and warm it up for several
minutes. While warming up, check for oil
leakage. If oil leakage is found, turn the
engine off immediately and check for the
cause.
10. Turn the engine off, and then check the
oil level and adjust it if necessary.
Final gear oil
The final gear case must be checked for oil
leakage before each ride. If any leakage is
found, have a dealer check and repair the
ATV.
Replacing the final gear oil
1. Place the ATV on a level surface.
2. Place a container under the final gear case
to collect the used oil.
3. Remove the oil filler bolt and the drain bolt
to drain the oil.
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO MASSIMO
To Next Page
Loading...
