operating your meter. Pay particular attention to WARNING. The
instructions in these warnings must be followed.
· You must be careful when working with voltages above 30V AC. Keep
fingers behind the probe barriers while measuring.
· Never use the meter to measure voltages that might exceed the
maximum allowable input value of any function measurement mode.
· Always inspect your meter and test leads before every use. If any
abnormal conditions exist: broken test leads, cracked cases, LCD not
reading, etc, do not attempt to take any measurement.
· Using the meter with the equipped test leads is only conform to safety
requirements. If you need instead broken test leads, you must replaced
with the same as type and electric specification.
· Never touch a voltage source when the test leads are plugged into a
current jack.
· Do not expose the instrument to direct sunlight, extreme temperature
or moisture.
READ THE INSTRUCTIONS BEFORE
USING THE INSTRUMENT
WARNING
Safety Information
Three-phase digital power clamp meter has been designed according
to IEC1010-1 and IEC1010-2-032 concerning safety requirements for
electrical measuring instruments and handheld clamps with pollution
degree 2, overvoltage category ( 600V CATⅢ).
- 1 –
To Next Page
Loading...
Need help?
General
